|
Modelengine
Ignition Spark Coil
 |
| Introducing the new
"Modelengine" Ignition Spark Coil. This coil is about half the size of the "Exciter" and will power most all of
Jerry's IC engines with no trouble (the exception is the V4, which we
recommend using the "Exciter" coil). This coil contains three prongs
at one end, one for +, one for -, and the third for the spark plug.
Like the "Exciter", the coils are totally enclosed in a plastic
cylinder and potted with epoxy. This makes them very rugged and
oil/fuel proof. These coils can be used on any model spark plug type
engine with the TIM-6 transistor ignition module.
Specifications: .980" Diameter by 1.250" long,
primary resistance: 1.2 Ohms, secondary resistance: 4.9K Ohms,
operating voltage: 4.8 to 6 volts DC |
|
Exciter
Ignition Spark Coil
 |
The
"Exciter" coil pictured at left, is small in
size (1.76" long by 1.4" diameter), weighs 4
ounces (113 grams) including three 8" long leads
and operates on 3.6 to 6 volts. The primary winding
resistance is 1 ohm. The coils are totally enclosed in a
plastic cylinder and potted with epoxy. This makes them
very rugged and oil/fuel proof. These coils can be used
on any model spark plug type engine with either the
TIM-6 transistor ignition module, or on engines with old
style conventional contact points and condenser
(capacitor). These come with an information sheet and if
requested, a capacitor for use
with contact points.
Note - (12/24/2008) These
now have only one secondary winding lead (white). The
other end of the secondary is connected internally to
the negative primary winding lead (black). Formerly,
they had two (white) secondary (spark voltage) leads as
pictured.
This coil is best suited for the Howell V-4 Engine. Quantities are
limited.
Only one coil per V4 plan purchase
|
Exciter
Ignition Spark Coil
Item
ID: Coil |
$59.00
|
|
|
